D0H -gb

Through flow sensor fitting,
Mod.D0H

Through flow cells designed to house up to four of the following electrodes: pH, ORP, ISE, conductivity, dissolved oxygen, temperature  and solution ground contact (available upon request).
The sensor fitting is made in PVC and Polycarbonate and includes an alluminium cap with IP 54 protection degree. The cell is supplied c/w brackets and accessories for wall mounting. Hydraulic connections are two, ½” F for sample inlet and drain. The cell can also be directly mounted on the pipeline where the sample is drawn for the measure using rigid piping for sample inlet and sample outlet.
The lower vessel, that is fixed to the probe through a threaded connection, can be used as calibration vessel.
These cells include 4 PG 13,5 threaded connections for the sensors. Each sensor must be supplied with S7 cable connector and PG 13,5 process connection, complete with O-Ring and gland.
The cell is supplied c/w 4 caps, PG 13,5 and 4 sets of PG 13,5 threaded nuts, with O-ring and gland for the installation of electrodes and cells.